Dell 6350 Rack Installation page 22

1-8 Dell PowerEdge 6x50 Systems Rack Installation Guide
NOTE: The vertical rails of the rack are marked by small indentations in 1-U incre-
ments (see Figure 1-6).
1 U (1.75 inches)

 !  
For more information about requirements for installing components in a Dell rack, see
the Dell Rack Advisor software available on the Dell World Wide Web site at:
http://support.dell.com.
To determine where to install the slide assemblies in the rack, perform the following
steps:
1. Place the front of the template on the vertical rails at the front of the rack where
you want to install the system.
The printing on the template identifies the side facing outwards as the template
front.
2. Position the bottom of the template where the system's lower edge will be
located.
3. Mark the rack's front vertical rails with a felt-tip marker or place masking tape
where the system's upper and lower edges will be located (see Figure 1-7). Make
a mark or place tape on the vertical rails next to the template's V-shaped notches.