Removing The Slide Assemblies From The Rack; Figure 1-8. Removing The Rails And Rack Adapters - Dell 4200 Installation Manual

1-10 Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide
10-32 x 0.25-inch screws (4)
securing each rail
rails (6)
rack adapters (2)
10-32 x 0.25-inch screws (3)
securing each rack adapter

Figure 1-8. Removing the Rails and Rack Adapters

2. Remove the rack adapters from each side of the system (see Figure 1-8) by
removing the three 10-32 x 0.25-inch Phillips-head screws that secure each rack
adapter to the side of the system.
3. Install a plastic filler plug (provided with the kit) into each hole on the top
(left side) of the system.

Removing the Slide Assemblies From the Rack

To remove the slide assemblies from the rack, perform these steps:
1. Remove the two 10-32 x 0.5-inch Phillips-head screws that secure the slide's
mounting bracket to the front of the rack.
install plastic filler plugs
on this side only