Removing The Front Bezel; Figure 1-12. Removing The System Cover - Dell 4200 Installation Manual

Dell poweredge 4200 servers: installation guide

Hide thumbs Also See for 4200:

Table of Contents

1-14

Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide

Removing the Front Bezel

To remove the system front bezel, perform these steps:

Remove the system cover (see Figure 1-12).

Turn the keylock on the back edge of the cover to the unlocked position.

Slide the cover about a centimeter (half an inch) toward the back of the

system.

Grasping the top of the cover at both ends, lift it away from the chassis.

With your fingertips, gently pry loose the four tabs along the right edge of the

bezel, and disengage the three clips on the opposite edge from the chassis

(see Figure 1-13).

Rotate the bezel to the left to disengage and remove it.

keylock

system cover

Table of Contents