Dell 2100 User Manual page 123

Jumper Setting
CARDBIOS
VGA
EISA
PASSWD
180MHZ
200MHZ
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
jumpered
Table B-1. System Board Jumpers
Default Description
Default System boots normally.
System boots from a BIOS expansion card. Used for troubleshooting.
Default The built-in video subsystem is enabled.
The built-in video subsystem is disabled.
Default The EISA Configuration Utility settings are retained at system boot.
The EISA Configuration Utility settings are cleared at next system boot. (If
the EISA Configuration Utility becomes corrupted to the point where the
system will not boot, install the jumper and boot the system. Remove the
jumper before restoring the EISA configuration information.)
Default Boot password features are enabled.
Boot password features are disabled.
Jumpered when the microprocessor's internal operating frequency is 180
MHz.
Unjumpered when the microprocessor's internal operating frequency is
200 MHz.
Jumpered when the microprocessor's internal operating frequency is 200
MHz.
Unjumpered when the microprocessor's internal operating frequency is
180 MHz.
unjumpered
Hardware Configuration Features B-123