Page 1
PERC 3/DC card in your PowerEdge 1550 or PowerApp 120 system. Installing the PERC 3/DC Card in Your System To install the PERC 3/DC card in a PowerEdge 1550 or PowerApp 120 system, perform the following steps.
Page 2
Prepare the PERC 3/DC card for installation, and open the system cover. For instructions, see your system’s Installation and Troubleshooting Guide. Disconnect the power supply cable from the system board. NOTE: Disconnecting the power supply cable will facilitate cable installation in step 9. Remove the SCSI backplane board from the chassis.
Page 3
Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden. Trademarks used in this text: Dell, the DELL logo, PowerEdge, and PowerApp are trademarks of Dell Computer Corporation. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products.
Need help?
Do you have a question about the PowerEdge 1550 and is the answer not in the manual?
Questions and answers