Table of Contents
Advertisement
Suunto EON Steel
6.3. Changing strap to bungee
You can change between the wrist strap and bungee as needed. The bungee is included in
the box of your Suunto EON Steel.
To install the bungee:
1. Remove the quick release strap.
2. Attach the bungee adapters.
3. Thread the cord through both adapters.
4. Securely tie the ends of the bungee cord and cut off excess cord.
6.4. Charging battery
Charge Suunto EON Steel with the supplied USB cable. For charging, use a USB port of 5
Vdc, 0.5 A as a power source. If the battery is very low, the display is off while charging until
the battery reaches an adequate charge level. When battery is so low that device cannot be
turned on, a red led is blinking next to the display. Blinking stops when battery has enough
power to start the device.
When device is on and and battery is charging, battery symbol in the upper left corner of the
display turns green.
WARNING: You must only charge your device using USB adapters that comply with the
IEC 62368-1 standard and have a maximum output of 5 V. Non-compliant adapters are a fire
hazard and a risk to personal injury and might damage your Suunto device.
CAUTION: DO NOT use the USB cable when Suunto EON Steel is wet. This may cause
an electrical failure. Ensure the cable connector and connector pin area on the device are
both dry.
CAUTION: DO NOT allow the connector pins of the USB cable to touch any conductive
surface. This may short circuit the cable, making it unusable.
Rechargeable batteries have a limited number of charge cycles and may eventually need to
be replaced. The battery should be replaced only by authorized Suunto Service Centers.
6.5. Getting support
To get additional support, visit www.suunto.com/support/dive-computers-and-instruments-
support/suunto-eon-steel/.
55
Advertisement
Table of Contents
