Table of Contents
Advertisement
Suunto EON Steel
6. Care and support
6.1. Handling guidelines
Handle Suunto EON Steel with care. The sensitive internal electronic components may be
damaged if the device is dropped or otherwise mishandled.
When travelling with this dive computer, ensure that it is packed securely in check-in or carry-
on luggage. It should be placed in a bag or other container where it cannot move around,
bumped or easily hit.
When flying, turn your dive computer to airplane mode under General » Connectivity.
Do not try to open or repair Suunto EON Steel by yourself. If you are experiencing problems
with the device, please contact your nearest authorized Suunto Service Center.
WARNING: ENSURE THE WATER RESISTANCE OF THE DEVICE! Moisture inside the
device may seriously damage the unit. Only an authorized Suunto Service Center should do
service activities.
Wash and dry the dive computer after use. Rinse very carefully after any salt-water dive.
Pay special attention to the pressure sensor area, water contacts, pushers, and USB cable
port. If you use the USB cable before washing the dive computer, the cable (device end)
should be rinsed as well.
After use, rinse it with fresh water, mild soap, and carefully clean the housing with a moist soft
cloth or chamois.
NOTE: Do not leave your Suunto EON Steel in a bucket of water (for rinsing). The display
stays on under water and consumes battery life.
Use only original Suunto accessories - damage caused by non-original accessories is not
covered by warranty.
WARNING: Do not use compressed air or high pressure water hoses to clean your dive
computer. These can permanently damage the pressure sensor in your dive computer.
TIP: Remember to register your Suunto EON Steel at www.suunto.com/register to get
personalized support.
6.2. Installing scratch guard
Use the provided scratch guard to help protect your Suunto EON Steel from scratches.
To install the scratch guard:
1. Ensure the display glass is clean and dry.
2. Peel back the protective layer from one end of the scratch guard.
3. Place exposed adhesive side down squarely on one end of the display.
4. Pull back the protective layer from the scratch guard.
5. Press out any air bubbles with a soft, straight edge tool.
Watch the video on YouTube.
54
Advertisement
Table of Contents
