Table of Contents
Advertisement
Suunto EON Steel
4.3. Changing strap to bungee
You can change between the wrist strap and bungee as needed. The bungee is provided as
an option.
To install the bungee:
1. Remove both strap ends using a TORX T7 (non-IP) screwdriver.
2. Attach the bungee adapters.
3. Thread the cord through both adapters.
4. Securely tie the ends of the bungee cord and cut off excess cord.
4.4. Charging battery
Charge Suunto EON Steel with the supplied USB cable. If the battery is very low, the display
remains dark while charging until the battery has reached an adequate charge level. A red
LED blinks next to the display when the device is charging.
CAUTION: DO NOT use the USB cable when Suunto EON Steel is wet. This may cause
an electrical failure. Ensure the cable connector and connector pin area on the device are
both dry. If you are using a protective boot, remove the boot from the connector pin area to
clear any residual water droplets.
NOTE: When connected, you may experience a tingling sensation when touching a
metallic computer housing and Suunto EON Steel. This is caused by a minor electrical current
created when the wall plug to the computer is not grounded.
CAUTION: DO NOT allow the connector pins of the USB cable to touch any conductive
surface. This may short circuit the cable, making it unusable.
Rechargeable batteries have a limited number of charge cycles and may eventually need to
be replaced. The battery should be replaced only by authorized Suunto Service Centers.
4.5. Getting support
To get additional support, visit www.suunto.com/support. There you will find a comprehensive
range of support materials, including Questions and Answers and instruction videos. You can
also post questions directly to Suunto or email/call Suunto support professionals.
There are also many how-to videos on the Suunto YouTube channel at www.youtube.com/
user/MovesCountbySuunto.
38
Advertisement
Table of Contents
