Telescopic Arm As An Accessory; Assembling The Telescopic Arm; Adjust The Height Of The Telescopic Arm; Adjusting The Working Angle - Grizzly AGS 3680 D-Lion Translation Of The Original Instructions For Use

Telescopic arm as an
accessory
Ensure that the safety key (
is removed before all tasks.
Caution! Device is delivered with-
out a telescopic arm. Alternatively,
a telescopic arm including wheels
can be ordered (see "Spare parts/
accessories").
Assembling the telescopic
arm
Putting the telescopic arm to-
gether:
1. Put both parts of the telescopic
arm (18) together and tighten
the screw.
Make sure that the cable is not
clamped.
Assembling/dismantling the
telescopic arm:
2. Push the device along the guide
rail (19) into the equipment
holder (20) of the telescopic
arm. It locks into place audibly.
3. Plug the plug connection (21)
into the charging socket (5) on
the back of the equipment han-
dle (4).
4. To dismantle, release the plug
connection (21). Press the un-
lock button on the bottom side
of the equipment holder (20) of
the telescopic arm and pull the
device out (see small image).
Adjust the height of the tel-
escopic arm
Adjust the length of the telescopic
7) arm for your size with the help of
the adjusting screw (22).

Adjusting the working angle

For a comfortable edge cut, the equip-
ment holder (20) of the telescopic arm can
be rotated to the right or left.
Set the desired position by pulling
the release switch (23) and rotat-
ing the equipment holder (20) of
the telescopic arm. The equipment
holder locks into the desired posi-
tion when the release switch is
released.
Switching on and off
(with telescopic arm)
1. Remove the blade guard (
11/13) before switching the de-
vice on.
2. Insert the safety key (
the device.
3. To switch on, hold the switch
lock (24) on the handle of the
telescopic arm and simultane-
ously press the on/off switch
(25). Release the switch lock,
device runs at top speed.
4. To turn it off, release the on/off
switch (25).
Working with the telescopic
arm
• Slowly push the device on the wheels
over the floor. By doing so, you will
achieve an even cutting height.
GB
7) into
79