Inserting/Replacing The Blade; General Working Instructions; Use As A Grass Trimmer; Use As A Hedge Trimmer - Grizzly AGS 3680 D-Lion Translation Of The Original Instructions For Use

Inserting/replacing the blade

Prior to each exchange of the
blades, make sure the device is
switched off and the safety key
and in order to avoid danger and
injuries!
Remove blade
1. Press the unlock buttons
(10/13) on the blade and re-
move the entire blade.
Insert blade
2. Insert the grass shear blade (9)
or the shrub shear blade (12)
into the recess in the cutter
head (1).
3. Press the blade into the direc-
tion of the cutter head (1). It
locks into place audibly.

General working instructions

While trimming, take care that
there are no objects such as wire,
metal parts, stones etc. come into
contact with the blades. This can
lead to cutting head damage. If the
blades become blocked by solid
objects, switch off the unit at once.
• Check the grass and bush trimmer
blades for obvious defects such as
loose, worn or damaged parts. Check
that the screws are seated firmly in
the blade block.
• Remove the power supply unit before
working with the equipment. Do not
use extension cables. The power sup-
ply unit is to be used only in enclosed
spaces.
• Only use sharp blades to achieve a
good cutting performance and pre-
serve the battery.
• Do not work the unit so hard that it
comes to a standstill.
• Pay attention to the instructions on
unit maintenance and cleaning.

Use as a grass trimmer

• Grass is best cut when dry and not
too long.
Adjusting the working angle
For a comfortable edge cut, the cutter head
(1) can be rotated by 90° to the right or left.
1. Operate the lever (3) and turn
the cutter head (1) into the de-
sired position.
2. Release the lever (3), the cutter
head locks into place.

Use as a hedge trimmer

• Move the unit forward evenly.
• The double-sided cutting heads en-
able cutting in both directions or by
swinging the unit from side to side.

Cleaning/Maintenance

Leave any work not covered in
this manual to our Service Cen-
tre. Only use original parts. There
is a risk of injury!
Ensure that the safety key (
is removed before all tasks.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
GB
7)
77