Factory Default Settings - NETGEAR S8000 User Manual

Nighthawk S8000 Gaming & Streaming Advanced 8-Port Gigabit Ethernet Switch (GS808E)

Factory Default Settings

You can return the switch to its factory default settings. Use the end of a paper clip or
some other similar object to press and hold the RESET button on the bottom panel of
the switch for at least five seconds. The switch resets and returns to the factory settings
that are shown in the following table.
Table 3. Factory default settings
Feature
Access point login and discovery
IP address
Login password
Switch discovery protocols
QoS
QoS port assignments
QoS mode
Port priority
Port rate limits
Flow control
Broadcast filtering
Port storm control rate
limits
Multicast
IGMP snooping
Blocking of unknown
multicast addresses
VLAN ID enabled for IGMP
snooping
Factory Default Settings and
Technical Specifications
Default Setting
DHCP client. Enabled. That is, an IP address is issued to the switch by a
DHCP server in the network.
Standalone IP address. 192.168.0.239 with subnet mask 255.255.255.0.
password
All enabled (UPnP, Bonjour, and NSDP)
Port 1. Gaming
Port 2. Media streaming
Port 8. Uplink
Port-based
High (all ports)
None (for all ports)
Disabled
Disabled
None (for all ports)
Enabled
Disabled
None
101 User Manual