Table of Contents
Advertisement
Delayed start
When you select Delayed start, the dishwasher will start 1-24
hours after you press the Start/Stop button.
1 Press the button once to activate Delayed start. Press the
button several times – or hold it in – to set the desired number
of hours.
2 Press Start/Stop and the dishwasher counts down 1 hour at a
time and starts after the selected delay.
Press and hold Start/Stop for three seconds if you want to cancel
the Delayed start option.
NOTE!
Remember to press the Start/Stop button to start the
programme.
START THE DISHWASHER
Press and hold Start/Stop until the display shows
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last programme run.
TIME REMAINING
Once you have selected a programme and options, the display
indicates how long the programme took the last time it was used.
The remaining time is updated after the water for the final rinse
has been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature and other factors.
NOTE!
During the first run of each programme, the remaining time
displayed can be slightly misleading, as the dishwasher is estimating
the time. When you run the programme a second time, the
dishwasher will calculate the remaining time based on the
previous duration of the programme.
STOPPING OR CHANGING A PROGRAMME
If you want to change programme after starting the dishwasher,
open the door then press and hold Start/Stop for three seconds.
Add more detergent if the lid of the detergent dispenser has
opened. Then choose a new programme, press Start/Stop and
close the door.
DO YOU WANT TO ADD MORE DISHES?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door and the dishwasher continues the
programme.
IF THE DISHWASHER IS TURNED OFF USING
(the door
THE ON/LEFT-ON MODE BUTTON OR DUE TO
A POWER FAILURE
If the dishwashing programme was not finished, the interrupted
programme continues when power is restored.
NOTE!
During drying, the programme is interrupted if the power is cut
or the door is open for more than 2 minutes.
ONCE THE PROGRAM HAS FINISHED
Once the programme has finished and the door is opened "End"
appears on the display.
A buzzer also sounds at the end of the programme. See the section
Settings, which describes how to change this function.
Once the dishwasher has finished, it uses only standby power. Turn
off the water supply valve after each use.
9
Advertisement
Table of Contents
