Display - Atag VA6811NT Operating Instructions Manual

Table of Contents

Advertisement

PROGRAMME SELECTION
Press the Programme selector one or more times until the desired
programme symbol appears on the display.
Auto wash
The dishwasher can measure how dirty the dishes are and adjust
water consumption and temperature accordingly. When newly
installed, the programme needs to be run five times before it is
fully adapted and can provide the best results.
Heavy wash
Programme for very dirty dishes, such as pans, casserole dishes
and oven dishes. If these dishes do not completely fill the
dishwasher, you can add plates and the like.
Normal wash
Powerful programme for daily use that can remove dried leftovers,
but is not intended for burnt food, such as on oven dishes. This
programme provides maximum rinse effect, and takes longer than
Daily wash.
Daily wash
This is also an effective programme for daily use for slightly dried
leftovers, but is not intended for burnt food, such as on oven
dishes.
Quick wash
This programme is used for glasses and porcelain that is slightly
dirty, such as coffee cups.
Super quick wash
Short programme lasting about 15 minutes with acceptable results
for very slightly dirty dishes.
Delicate wash
If the dishes are not very dirty, you can select Delicate wash. This
programme is intended for glasses and porcelain that have just
been used and as such do not require such a powerful programme.
This programme can be used for fragile dishes. Select Short dry if
you want to be especially cautious. See also the section Fragile
dishes in the chapter Loading the dishwasher.
8
Eco wash
This programme is intended for cleaning normally dirty dishes and
is the most effective programme in terms of combined energy
and water consumption.
The High temperature option must be selected to access the
programme used to compile the information for energy labelling.
Rinse & Dry
This programme comprises a rinse with heating and drying. This
is a suitable programme if, for example, you plan to make jam and
want to rinse and heat clean glass jars.
Rinse & Hold
Used to rinse dishes while you wait for the dishwasher to become
fully loaded.
SELECTING OPTIONS
To select an option, press one of the option buttons. The field
under the button lights when the option is activated. The available
options depend on the selected programme. Once you have
started the programme, the options you selected are saved for
the next time you use the same programme. An exception is the
Delayed start option.
High temperature
Activate this option for improved dishwashing results. The machine
then uses a higher temperature for the main wash.
If you want to use the lower temperature, press again so that the
field under the button turns off.
You can vary the temperature as shown below:
Heavy wash:
55 °C / 70 °C
Normal wash:
60 °C / 65 °C
Daily wash:
60 °C / 65 °C
Quick wash:
30 °C / 60 °C
Super quick wash:
30 °C / 60 °C
Delicate wash:
40 °C / 50 °C
Eco wash:
50 °C / 60 °C
Long dry
A higher temperature in the final rinse and a longer drying phase
improves the drying result if you activate the Long dry option. This
causes a slight increase in energy consumption. This option can be
used with all programmes except Rinse & Dry and Rinse & Hold.
If you want a programme with Short dry, press again so that the
field under the button turns off.

Advertisement

Table of Contents
loading

Table of Contents