Heatilator NNXT33-IFT Installation Manual page 54

LOG PINS LOG PINS
Figure 4. Log Pin Locations
Log #5: Place Log #5 into position. The forked end of
Log #5 is positioned on the log pins as shown in Figure 5.
The back end of Log #5 will rest on Log #4, but does not
touch Log #1.
1 1
Figure 6. Locations of Flat Spots for Log #6
Log #6: Place Log #6 into position by setting the large
end on the flat spot in Log #3 and then resting the small
end on the flat spot on Log #1.
54 Heatilator • NNXT33-IFT, NNXT33L-IFT, NNXT36-IFT, NNXT36L-IFT Installation Manual • 2628-980 Rev. C • 8/20
FLAT SPOTS FOR LOG #6 FLAT SPOTS FOR LOG #6
3 3
LOG PINS LOG PINS
Figure 5. Log #5 in Position
4 4
2 2
Figure 7. Log Set Installed
DOES NOT TOUCH LOG #1 DOES NOT TOUCH LOG #1
5 5 1 1
1 1
6 6
3 3
5 5
2384-935B