Table of Contents
Advertisement
Rear Vent
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
•
Fold the tabs toward the center of the vent cap (90º)
and remove the insulation gasket.
Figure 6.7
•
Cut the metal retaining band and fold the sides out.
Figure 6.8
•
Fold the center parts of the retaining band out and use
to remove the vent cap.
Figure 6.9
Heatilator • NNXT33-IFT, NNXT33L-IFT, NNXT36-IFT, NNXT36L-IFT Installation Manual • 2628-980 Rev. C • 8/20
•
Discard the vent cap, remove and discard the insulation
basket.
Figure 6.10
•
Attach the first vent section (it will snap into place). Slide
the insulation gasket onto the vent section, up against
the appliance and over the tabs.
Figure 6.11
35
Advertisement
Table of Contents
