VERDER CARBOLITE GERO HZS 12/900 Installation, Operation And Maintenance Instructions page 27

1
Type 'Rate'
Target 400°C Duration 30 min Target 600° Duration 30 min
Rate 5.0°/Min
3.8.15 Program Example 2
The following sequence of entries creates and runs the program shown graphically
below.
1. Turn the 'Setpoint' to '0' by pressing down
2. Press page until 'Prog Segments Used' is displayed. On P10 and P25 models press
up or down to select a new program number, (a program with only 1 segment).
3. Press scroll until 'Holdback Value' is displayed. Press up
degrees
4. Press scroll until 'Ramp Units' is displayed. Press up
Time Display Examples
10:05:3 Min/Sec/10th Sec
21:10:05 Hour/Min/Sec
196:10 Hour/Min
Segment
2 3
Type 'Dwell' Type 'Step'
4 5
Type 'Dwell' Type 'Time'
Target 200°
Time 120 min
or down
3.0 3508 Controller
6
Type 'End'
End Type 'Reset'
or down to set to '5'
to set to 'Min'
27