VERDER CARBOLITE GERO HZS 12/900 Installation, Operation And Maintenance Instructions page 28

3.0 3508 Controller
5. Press scroll
6. Press scroll
7. Press scroll
'Time'
8. Press scroll
9. Press scroll
degrees
10. Press scroll
'30:00.0' minutes
Repeat steps 6 to 10 for 4 more segments. Enter the following parameters and values:
Note: Call segments are not available on single program models.
Segment Type Rate
Segment Type Step
Segment Type Dwell
Segment Type Call
Finish the program with an End segment:
11. Press scroll
'End'
12. Press scroll
Repeat the sequence to create a short program '3' as suggested in the diagram.
13. Press page
To operate the program either press RUN/HOLD or
14. Press page
15. Press scroll
16. Press to select 'Run'
28
until 'Cycles' is displayed. Default '1'
until 'Segment 1' is displayed
until 'Segment Type' is displayed. Press up
until 'Holdback Type' is displayed. Default 'Off'
until 'Target SP' is displayed. Press up
until 'Duration" is displayed. Press up
Target SP '400' degrees. Ramp Rate '2.0' degrees per
minute
Target SP '200' degrees
Holdback 'High'. Duration '30:00.0' minutes
Call Prog 'next number'. Call Cycles '2'
until 'Segment Type' is displayed. Press up
until 'End Type' is displayed. Press up
and scroll together to return to the home display
until 'Program Status' is displayed
until the cursor moves to the program status of 'Reset'
or down to select
or down to set to '600'
or down to set to
or down to select
or down to select 'Dwell'