Dell Inspiron 3700 Reference And Troubleshooting Manual page 70

3-22 Dell Inspiron 3700 System Reference and Troubleshooting Guide
5. Turn the computer over and remove the memory module cover and the memory
modules.
Refer to "Installing Memory Modules" in Chapter 2.
6. Install the new memory module(s).
Refer to "Installing Memory Modules" in Chapter 2.
7 . Replace the memory module cover.
8. Reboot the computer, and press <F2> when prompted to enter the System
Setup program.
9. Call Dell for technical assistance.
See Chapter 5, "Getting Help," for instructions.
If the computer is receiving power, but nothing appears on your display (such as light,
text, or graphics) or the display image does not appear as you would expect, make a
copy of the Diagnostics Checklist found in Chapter 5 and fill it out as you perform the
following steps.
NOTE: Extended graphics array (XGA) displays support 1024 x 768 pixels, and
super extended graphics array (SXGA) displays support 1280 x 1024 pixels. If your
application program uses a higher resolution, you must attach an external video
graphics array (VGA) monitor to your computer.
1. If the computer is running, press any key on the integrated keyboard. Is the full
display readable?
Yes. The computer was in standby or suspend mode. The problem is resolved.
No. Go to step 2.
2. Is an external monitor connected to the computer?
Yes. Go to step 3.
No. Go to step 4.
3. Press the <Fn><F8> key combination. Is the full display readable?
Yes. The problem is resolved.
No. Go to step 8.
4. Turn off the computer and any attached peripherals. Disconnect all peripherals
from the computer.
5. Make sure the AC adapter is firmly connected to the computer and to an
electrical outlet, or verify that a fully charged battery is properly seated in its bay.