Table of Contents
Advertisement
3
Place the next module in the row, as shown
in Figure 38. If no module is directly adjacent
in the row, completely install the first module
with four (4) KBK End Clamps.
Click-in
and
modules.
The adjacent module must be in place before
completely installing the KBK Mid Clamp.
4
Completely secure the first module. Use a
3/16" Allen Bit/5mm Hex Drive, tighten all
Clamps with a standard drill or torque
wrench.
Torque to 8.3Nm (6.1ft-lb).
NOTE: To prevent damage to module and
clamp, do not exceed recommended torque
setting above.
Do not use hammer drills, impact drivers, or
long Allen keys.
5
Continue installing modules in the first row.
Once complete, move to the next row of
modules.
Use your Spacing Diagram to determine the
required gap between rows.
Repeat steps 2-5 until the entire array is
completed.
NOTE: KB Konnect Clamps are designed for
single use only. If KBK Clamps are removed
for maintenance purposes, please re-install
using a new KB Konnect Clip.
Rev.1, Sep 2019
secure
Clamps
between
Figure 38 – Mid Clamp Placement
Figure 39 – Installed KB Konnect Mid Clamp
Figure 40 – Installed Array
Page 27 of 38
Advertisement
Table of Contents
