KB Racking BARN RACK 2.0 Installation Manual page 15

L-FOOT ORIENTATION
L-Feet must sit as perpendicular as possible to the roof surface. This is controlled by
properly installing the roof attachment. An improperly installed L-Foot will prevent proper
installation of BarnRack 2.0.
Always rotate and orient the L-Feet as shown in the figure below. This is recommended
to keep the installation consistent throughout the array.
Figure 11 – L-Foot Orientation
LOCKING T-BOLT
The M8 T-Bolt features an indicator which confirms engagement with the Rail. When
securing the T-Bolt, ensure the indicator remains in the vertical position.
Figure 12 –Vertical Position showing Engagement
KB KONNECT END CLAMP VARIATIONS
At array ends, modules that are 40mm (1.57") in thickness will use Integrated End Clamps.
Other module thicknesses will use KB Konnect Clamps with End Blocks matching the
module thickness.
Left Right
Figure 13 – Integrated End Clamp ( ), KB Konnect Clamp with End Block ( )
Rev.1, Sep 2019 Page 15 of 38