Stop; Safe Work-Zone; Woodchipping; In The Event Of A Blocked Chute - P.Lindberg 90 54 661 Original Manual

6. If you engaged the choke, slowly disengage it when the engine is running satisfactorily.
7. If the engine is cold, it can be warmed up at half throttle (the middle position) for 3-4
minutes, after this give it full throttle.

Stop:

1. Set the throttle on idle (the position furthest to the right).
2. Put the on/off switch at "OFF".

Safe work-zone:

Support
Engine

Woodchipping:

NOTE – the diameter of branches and pieces of wood may not exceed 100 mm.
WARNING – Never put your hands in the chute when it is being filled. This is a
very DANGEROUS method and can cause severe injury to your hands.
Do not feed or step out in front of the feed chute area while the woodchipper is
running. This is a very DANGEROUS method that could cause personal injury or death.

In the event of a blocked chute:

If anything gets stuck in the disks while chipping wood, stop the engine and remove
the stuck material. Then re-start the engine and resume woodchipping.
P. Lindberg A/S
Tel.: +45 7021 2626
Seen from above
14
Sdr. Ringvej 1
DK-6600 Vejen
Work-zone
Feed chute
Work-zone
e-mail: salg@p-lindberg.dk
MAN 9054661 EN V3
www.p-lindberg.dk