Panasonic ES‑LV5C Operating Instructions Manual page 32

1
Apply some hand soap and some
water to the system outer foil�
2
Press for more than
2 seconds to activate the sonic
vibration cleaning mode�
• Splashing of foam is suppressed.
• The battery capacity lamps blink
in order.
• After about 20 seconds, it will be
automatically turned off, or you can turn it off by
pressing the power switch.
3
Remove the outer foil section
and clean with running water�
• See page 33 for attaching and
removing the outer foil section.
• Splashing is reduced by rinsing
the shaver in sonic vibration cleaning mode.
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture and
then wipe off any drops of water with a dry cloth.
4
Dry the outer foil section, the
shaver, and the trimmer
completely�
• Allow the shaver to dry in the
shade, avoid direct sunlight.
32
5
Lubricate the shaver�
It will keep the movement of the
blade smooth and maintain a
comfort shave.
1. Apply one drop of oil to each of
the system outer foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
five seconds.
4. Switch off the shaver, and wipe off any excess oil
from the system outer foil with a soft cloth.
The mark on the left means suitable for
cleaning under an open water tap�
Warning
Disconnect the cord from the shaver before
cleaning it in water to prevent electric shock.
Notes
• Be careful not to hit the main body on the sink or any
other object while draining the water. Failure to do so
may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, or cracking or
discoloration of the parts.
Wipe with diluted soapy water.
• Do not use any kitchen or bathroom detergents other
than hand soap.
Doing so may cause malfunction.