Thermostat Control; Filling The Water Reservoir - Beem S9.4.0 Manual

EN
Heating control lamp
The heating control lamp (11) lights up blue as soon as the heating element of the device
starts heating the water. The heating control lamp lights up at intervals when the water is
being kept warm and when boiling at intervals.

Thermostat Control

The thermostat control (9) is used to switch the device on and off and set the temperature
of the water. The following settings can be selected with the thermostat control:
O The device is switched off.
Warm water
Hot water
Boiling water
The heating control lamp
starts heating the water. The control lamp lights up at intervals when the water is being
kept warm and when boiling at intervals.
Removing / Attaching the Lid
1. Hold the lid (4) at the lid handles (15).
If the device has been in operation, use potholders or similar gloves as the lid might
be hot. Always allow the device to cool down before using it again.
2. To close the lid, place it on straight and press it down fi rmly with a little force. It must
click audibly into place and sit fl at.
3. To take off the lid, turn it anticlockwise to the
4. To close the lid, place it on and turn it clockwise to the
place.
5. Place the teapot (3) on the lid. This closes off the device at the top.

Filling the Water Reservoir

Only ever fi ll the water reservoir (7) with fresh, clear tap water. Do not pour in any
other liquids.
1. Take off the lid (4) (see the "Removing / Attaching the Lid" section).
2. Pour the desired quantity of water (maximum 4 litres) into the water reservoir. Note the
MAX marking.
3. Close the lid (see the "Removing / Attaching the Lid" section).
(11) lights up as soon as the heating element of the device
and pull it upwards.
. The lid is now locked in
28