Before Initial Use; Operation; Control Lamps - Beem S9.4.0 Manual

27

Before Initial Use

NOTES
• Always set up the device with a clear space at the sides (at least 20 cm) and clear
space above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is
resistant to splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and
soften the adjustable feet of the device. If necessary, place a suitable pad below
the adjustable feet.
• There may still be some production residues on the device. To avoid harmful
effects to your health, clean the device thoroughly before you fi rst use it (see
the "Cleaning and Care" chapter).
1. Fully unwind the mains cable.
2. Set up the device in a suitable location, following the safety instructions and the notes
provided at the beginning of this chapter.
3. Ensure that the On / Off switch and thermostat control (9) is in the
4. Insert the mains plug into a properly installed socket that is easily accessible.
5. Before you fi rst enjoy tea or hot instant beverages, we recommend that you carry out
a trial run to remove any possible production residues. To do this, follow the instruc-
tions in the "Operation" and "Preparation" chapters.
When the device is fi rst used, production-related additives (e.g. grease) may cause a
small amount of smoke and / or an odour to be produced. This is normal and not a
device defect.
6. Perform this process twice if necessary. Caution! Do not drink this water!
7. Clean the device and accessories (see the "Cleaning and Care" chapter).

Operation

Control Lamps

Dry-running protection control lamp
The dry-running protection control lamp (10) lights up red to warn that there is no water
or not enough water in the water reservoir (7). In this case, the dry-running protection is
activated and the heating of the device is automatically switched off.
EN
O (Off) position.