Error Messages; Internal Peripherals - RaycoWylie i4500 Instruction Manual

5.7

Error messages

sYsTEm
ERROR
INdIcATOR

5.7.1 Internal Peripherals

If you have any questions or need technical assistance, please contact our technical
service department at RaycoWylie.
Error messages
•calibration's data memory is
defective, or
Operator's data memory is
defective, or
Load chart data memory is
defective, or
data Logger memory is
defective
RAm memory is defective
clock is defective
Low battery
i4500 Lattice Boom Crane
During start up and other operation processes, the
i4500 system analyses all interactions between internal
peripherals (memories, controllers, extension cards, etc.)
and external peripherals (various interfaces connected to
the Canbus network). An error message will appear on the
main screen if an error is detected.
Execution process
When starting system, there
is a verification (writing/
reading) of the whole flash
memory on the engine board
When starting system, there
is a verification (writing/
reading) of the RAM
memory on the engine
Board.
The system regularly verifies
if the seconds are moving. If
time does not change, then
there is a problem
The system detected that
the lithium battery is low.
Because of this, the clock
may stop or lose precision.
78
55M4500EBE00A-A
cause of error
There is a problem with
the flash memory on the
engine board located in the
i4500 display
Contact the technical service
department at RaycoWylie.
There is a problem with
the RAM memory on the
engine board located in the
display
Contact the technical service
department at RaycoWylie
1) Verify if the battery on the
mother board in the display is
well inserted.
2) The clock chip is defective
on the mother board
The lithium battery is out.
Replace the battery on the
mother board
Instruction Manual