Error Messages; Internal Peripherals - RaycoWylie i4500 Instruction Manual

5.7

Error Messages

During start up and other operation processes, the i4500 system analyses all
interactions between internal peripherals (memories, controllers, extension
cards, etc.) and also external ones (various interface connected to the Canbus
network)
5.7.1

Internal Peripherals

If you have any questions or need technical assistance, please contact our
Technical Service Department at RaycoWylie.
error message
Calibration's data memory
is defective, or
operator's data memory is
defective, or
load chart data memory
is defective, or
data logger memory is
defective
ram memory is defective When starting system, there
Clock is defective
low battery
Telescopic Crane i4500
execution process
When starting system, there
is a verification (writing/
reading) of the whole flash
memory on the Engin board
is a verification (writing/
reading) of the RAM
memory on the Engin
Board
The System regularly verifies
if the seconds are moving. If
time does not change then
there is a problem.
The System detected that the
Lithium battery is low. This
may cause clock to stop or
lose precision.
73
i4500 Troubleshooting
Cause of error
There is a problem with
the flash memory on the
Engin board located in the
4500 Display
Contact the Technical
Service Department at
RaycoWylie
There is a problem with
the RAM memory on the
Engin board located in the
Display
Contact the Technical
Service Department at
RaycoWylie
1) Verify if the battery on
the Motherboard in the
display is well inserted.
2) The Clock chip is
defective on the Mother
board
The lithium battery is out.
Replace the battery on the
Mother board
Instruction Manual