Tips For Energy Saving - BOMANN GS 2181 Instruction Manual

Household freezer

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Defrosting

To achieve better cooling and to save energy, defrost the appliance regularly. To start the defrosting process

disconnect the plug or turn off the fuse. Remove the food items and keep covered at a cool location. When the

ice has melted, wipe the condensate away and dry the device interior. You may then restart the device by

connecting the plug and turning the temperature control.

CAUTION

CAUTION: : : :

CAUTION

Never use metal objects (e.g. knives) for removing ice from the vaporizer. The vaporizer could be damaged.

A defect vaporizer could cause serious damages.

NOTE:

In order to speed up the defrosting process, you may put a bowl of warm water (about 50°C) into the freezer

chamber.

Operating noise

Type of sound

Normal

Mumbling

Normal

noise

Liquid sounds

Click sounds

Disturbing noises

Switching off

Switching

off

Switching

off

Dis

Disconnect the mains plug or switch off the fuse in order to switch

Dis

connect the mains plug or switch off the fuse in order to switch off the

connect the mains plug or switch off the fuse in order to switch

If the appliance is out of use for long periods:

• Remove the appliance content.

• Thoroughly clean the appliance (see "Cleaning").

• Leave open the appliance door to prevent unpleasant odours.

• Disconnect the plug if you do not use the appliance.

• Do not install the appliance near stoves, heaters or other heat sources. In case of higher ambient tempera-

tures, the compressor will run more frequently and longer.

• Ensure sufficient ventilation at the bottom and rear side. Never block ventilation openings.

• Allow warm dishes to cool down before putting them in the appliance.

• Do not adjust the temperature colder than necessary.

• Make sure that the temperature in the freezer does not rise above -18°C.

• Do not open the door longer than necessary.

• The appliance should be defrosted regularly.

• The seal of the appliance door must be completely intact, so that the door closes properly.

Cause / solution

Caused by the compressor during its operation.

This is stronger when it turns on or off.

Caused by the circulation of the refrigerant in the appliance.

The temperature control turns the compressor on or off.

Vibration of the shelves or cooling coils – check if those are securely fastened.