Installation - BOMANN GS 2181 Instruction Manual

Conditions for the installation location Condition Condition Condition s for the installation location s for the installation location s for the installation location
NOTE: : : : NOTE NOTE NOTE
The unit has wheels which facilitate the transportation and installation of the appliance. Tilt the appliance back
slightly and move it gently.
• Good ventilation is required around the appliance, in order to dissipate the heat properly and to guarantee
efficient cooling operation at low power consumption. Sufficient clearance must be created for this pur-
pose:
Gap to the back and to the side walls each approx. 10 cm;
-
Clearance above the unit about 30 cm and
-
Clearance to the front must be created so that the appliance door can open without being impeded.
-
• Only install at a location with an ambient temperature suitable for the climate class of the appliance. For
information on the climate class refer to the chapter "Technical Data" or to the rating label located in the in-
terior or at the appliance back.
• Place the appliance on a steady and safe surface. If the appliance is not horizontally leveled, adjust the
feet accordingly.
• Install the appliance for the wall socket to be freely accessible.
• Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or any other heat sources;
-
at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be susceptible to cor-
-
rosion under such circumstances;
near volatile or flammable materials (e.g. gas, fuel, alcohol, paint, etc.) and in rooms which may have
-
poor air circulation (e.g. garages).
Assembling the door handle Assembling the door handle Assembling the door handle Assembling the door handle
Attach the door handle by removing the cover caps from the door outer side and tighten the handle with the
delivered screws into the underlying holes. Put the included screw covers on.
Electrical connection Electrical co Electrical co Electrical co nnection nnection nnection
WARNING: WARNING:
WARNING: WARNING:
• The installation to the mains supply must conform to the local standards and regulations.
• Improper connection may cause to an electric shock
• Do not modify the appliance plug. If the plug does not fit properly to the outlet, let install a proper outlet by
an authorized specialist.
• The accessibility of the power plug must be ensured in order to disconnect the appliance from the power
supply in case of an emergency.

Installation

Installation
Installation Installation
electric shock!
electric shock electric shock
20