After Operation; After Operation Safety; Cleaning Under The Machine - Toro Super Recycler 21681 Operator's Manual

•
If there are more than 13 cm (5 inches) of leaves
on the lawn, mow at a higher cutting height and
then again at the desired cutting height.
•
Slow down your mowing speed if the machine
does not cut the leaves finely enough.

After Operation

After Operation Safety

General Safety
•
Always shut off the machine, wait for all moving
parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.

Cleaning under the Machine

Service Interval: Before each use or daily
For best results, clean the machine soon after you
have completed mowing.
1. Lower the machine to the lowest cutting-height
setting. Refer to
(page 9).
2. Move the machine onto a level surface.
3. Attach a garden hose that is connected to a
water supply to the washout port
1. Washout port
4. Turn the water on.
5. Start the engine and run it until there are no more
clippings that come out from under the machine.
6. Shut off the engine.
7. Shut off the water and disconnect the garden
hose from the machine.
8. Start the engine and run it for a few minutes to
dry the underside of the machine.
9. Shut off the engine and allow it to cool.
13
Adjusting the Cutting Height
(Figure
Figure 19
19).
g014538