Caster Installation; Caster/Leg Mounting Detail - Delfield 403 Service And Installation Manual

Compact Refrigerators and Freezers Service and Installation Manual
Caster Installation - 400 & 4000 Series
400 & 4000 Series caster installation
1) Carefully place the unit on its back (see illustration at right).
2) Remove legs by unscrewing them in a counter clockwise direction.
3) Located on each end of the compressor channel are 4 hex head screws, for a total
of 8 screws. Remove them. 8 additional screws are provided with your casters.
4) Place a locking plate caster over one of the front holes, matching the 4 mounting
holes to the pre-drilled holes in the underside of the unit. Insert 4 hex head screws
and tighten. Repeat with the other locking front casters.
5) Repeat step 4 with the non-locking casters in the rear of the unit.
6) Carefully lift the unit upright.
7) After installing casters, the unit should be left in an upright position for at least
twenty-four (24) hours before starting.
NOTE: Check parts list for correct caster application.

Caster/Leg Mounting Detail

2", 3" and 5" Caster and Leg Mounting Detail
A universal bolt hole pattern is provided on the bottom of the cabinet. It will accom-
modate any leg or caster. Simply line up the plate holes with the corresponding
cabinet holes.
3.40"
NOTE:
If hole pattern on caster/leg
matches the one above
mount in outer set of holes.
6" Leg - 3234569
6
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
1.75"
2.82"
NOTE:
If hole pattern on caster/leg
matches the one above
mount in middle set of holes.
3" Caster - 3234024
5" Caster - 3234161
Plate Casters
W/O Locks
#14 x .75" Hex Head
Screws #932-1116
Plate caster installation, 400 & 4000 Series.
0.94"
2.14"
NOTE:
If hole pattern on caster/leg
matches the one above
mount in inner set of holes.
2" Caster - 3234148
Plate Casters
W/Locks