EINHELL BT-HP 200 Operating Instructions Manual page 11

Anleitung_BT_HP_200_SPK1:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
2. Layout and items supplied (Fig. 1)
1. High-pressure connection for hose reel
2. Hose reel lock
3. Handle
4. Screw connection for high-pressure hose
5. High-pressure hose
6. Hose reel
7. Crank (swing-out type)
8. High-pressure cleaner
9. ON/OFF switch
10. Cable holder
11. Pressure indicator
12. Water inlet connector
13. Connector for high-pressure hose to device
14. Transportation wheels
15. Holder for gun/accessories
16. Power cable
17. Mains plug
19. Integrated 1 liter tank for cleaning product
20. Cap for cleaning product tank
21. Lance point / wide cone
22. Gun
23. Trigger lever
24. Connector for high-pressure hose to pistol
25. Rotating washing brush
27. Safety pin (Fig. 9)
28. Water intake filter (Fig. 14)
29. Adapter
01.07.2008 8:57 Uhr Seite 11
3. Proper use
The high-pressure cleaner is designed to clean
vehicles, machines, buildings, facades, etc. in the
private sector.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage: 230 V ~ 50 Hz
Power input:
Working pressure: 12 MPa (120 bar)
Operating pressure (EW bar): 20 MPa (200 bar)
Delivery rate:
Max. water inlet pressure: 0.4 MPa (4 bar)
Sound pressure level L :
pA
Sound power level L :
WA
Weight:
5. Before putting the machine into
operation
Correctly using the device
b The high-pressure cleaner must be set upright
on a level, stable surface.
b It is recommended that you maintain the correct
operating position every time you use the
machine by placing one hand on the pistol and
the other on the lance.
b Never direct the water jet toward electrical lines
or the machine itself.
b It is normal for the pump to leak a little; this is
necessary to avoid damage to the pump when it
is at a standstill.
b Never use the equipment in potentially explosive
areas under any circumstances!
b The operating temperature must be between +5
and + 60°C.
GB
2,200 W
7 l/min
84 dB
95 dB
23 kg
11