Mistral LBS430PR Installation Manual And User's Manual page 8

2. INSTALLATION INSTRUCTIONS (continued)
ELECTRICAL INSTALLATION
WARNING
THIS RANGE HOOD MUST BE PROPERLY GROUNDED. TURN OFF ELECTRICAL POWER AT SERVICE
ENTRANCE BEFORE WIRING. MAKE SURE THAT THE ELECTRIC CORD IS NOT IN CONTACT WITH THE
SHARP EDGES OF THE APPLIANCE.
IMPROPER GROUNDING CAN RESULT IN A RISK OF ELECTRIC SHOCK. CONSULT A QUALIFIED
ELECTRICIAN IF THE GROUNDING INSTRUCTIONS ARE NOT COMPLETELY UNDERSTOOD OR IF DOUBT
EXISTS AS TO WHETHER THE APPLIANCE IS PROPERLY GROUNDED. DO NOT USE AN EXTENSION
CORD. IF THE POWER SUPPLY CORD IS TOO SHORT, HAVE A QUALIFIED ELECTRICIAN INSTALL AN
OUTLET NEAR THE APPLIANCE.

RISK OF ELECTRIC SHOCK. THIS APPLIANCE MUST BE GROUNDED.

In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing
an escape wire for the electric current. This appliance is equipped with a cord having a grounding
wire with a grounding plug. The plug must be connected to an independent outlet that is properly
installed and grounded.

A 110‐120‐volt, 60 Hz, AC‐only, fused electrical supply is required on a separate 15‐amp circuit,
fused on both sides of the line.

Do not ground to a gas pipe.

The range hood should be connected directly to the fused disconnect (or circuit breaker) box
through flexible armored or non‐metallic sheathed copper cable. A U.L. ‐ or C.S.A. ‐ listed strain
relief must be provided at each end of the power supply cable. Do not use extension cord or
adapter plug with this appliance.

Set the electrical power supply within the space covered by the decorative chimney.

Position the outlet offset so that the power cord will not interfere with the round duct.

Make sure this does not interfere with a mounting bracket fastening area or with the decorative
chimney (where the chimney touches the wall).
IMPORTANT
It is the customer's responsibility, t
the electrical installation is adequate and is conform with National Electrical Code, ANSI/ NFPA 70 —
latest edition*, or CSA Standards C22. 1‐94, Canadian Electrical Code, Part 1 and C22. 2 No. 0‐M91 ‐
latest edition** and all local codes and ordinances
o contact a qualified electrical installer. Please make assure that
8