Important Safety Measures - Mistral LBS430PR Installation Manual And User's Manual

1. IMPORTANT SAFETY MEASURES
READ AND SAVE THESE INSTRUCTIONS
CAUTION
For residential use only. Do not use to exhaust hazardous or explosive materials and/or vapors.
CAUTION
The range hood may have very sharp edges; please wear protective gloves when installing, cleaning
or servicing the unit.
This appliance must be installed by a qualified technician. The manufacturer declines all
responsibility in case of failure to adhere to safety standards. Install this hood in accordance with
all the specified requirements.
WARNING
To reduce the risk of fire, electric shock, or injury to persons, observe the following:

Use this unit only in the manner intended by the manufacturer. If you have any questions, contact
the manufacturer.

Before servicing or cleaning the unit, switch power off at the service panel and lock the service
disconnecting means to prevent power from being switched on accidentally. If the service
disconnecting means cannot be locked, securely fasten a noticeable warning device, such as a
tag, to the service panel.
 Installation work and electrical wiring must be done by a qualified person in accordance with all
applicable codes & standards including fire rated construction.
 Sufficient air is needed for proper combustion and exhausting of gases through the chimney for
fuel burning equipment to prevent back‐drafting.
 Follow the heating equipment manufacturer's guideline and safety standards such as those
published by the Canadian Fire Safety Association (CFSA), the American Society for Heating,
Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities.
 When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden
utilities.
 Ducted fans must always vent to the outdoors.
 Do not alter the original wiring.
 Do not attempt to repair or replace any part of your hood unless it is specifically recommended
in this manual.

All other servicing should be referred to a qualified technician
.
3