Swc Input Operation - Jensen CAR10 Installation & Owner's Manual

10.1”capacitive touch screen 2 din multimedia mechless receiver

Hide thumbs

Table Of Contents

Table of Contents

The built-in SWC Interface is compatible with PAC steering wheel control modules. The

PAC SWI-RC is recommended. A third-party adapter must be used in order for the CAR10

to be compatible with any steering wheel controls. The following controls are available for

most vehicles.

1. Reset

2. Mode

3. Seek/Track Up (+)

Note: Not all OE steering wheel functions may be supported by the CAR10.

1. Set "Radio Select Switch". Set the SWI-RC to position 7 - "Pioneer/Other/Sony".

2. To program, use the Pioneer/Sony/Other radio function mapping order for JENSEN units.

3. When programming the SWI-RC, if a function is not supported (or not desired), then the

function MUST be skipped as per the PAC SWI-RC instructions.

4. The SWC function MUST be programmed in the correct order per the PAC SWI-RC radio

function mapping order instructions.

Function

Order

Seek + / Track +

Seek - / Track -