Swc Input Operation - Jensen CM901MIR Installation & Owner's Manual

Multimedia receiver with usb mirror

Hide thumbs

Table Of Contents

Table of Contents

The built-in SWC Interface is compatible with 3rd party steering wheel control modules.

Either the PAC SWI series or Axxess ASWC-1 are recommended. These adapters must

be used in order for the CM901MIR to be compatible with any steering wheel controls. The

following controls are available for most vehicles.

1. Reset

2. Mode

3. Seek/Track Up (+)

Note: Not all OE steering wheel functions may be supported by the CM901MIR.

3.5mm SWC port located on the rear of the unit, on the MAIN POWER I/O Harness.

AXXESS Installation Hints

The ASWC-1 is auto programing for most vehicles. For full details,follow the AXXESS

vehicle info and programing from their website at: https://axxessinterfaces.com/product/

ASWC-1#vehicle-specific.

1. Set "Radio Select Switch". Set the SWI-RC to position 7 - "Pioneer/Other/Sony".

2. To program, use the Pioneer/Sony/Other radio function mapping order for JENSEN units.

3. When programming the SWI-RC, if a function is not supported (or not desired), then the

function MUST be skipped as per the PAC SWI-RC instructions.

4. The SWC function MUST be programmed in the correct order per the PAC SWI-RC radio

function mapping order instructions.

Function

Order

Seek + / Track +

Seek - / Track -