Nature Power Solar Security Light 1600 User Manual page 5

1，Before the Solar Motion Light can operate to its full capacity, allow the unit to charge in sunlight for
2 days with the solar panel wire connected to the light. Charging should be done with the unit in the
"OFF" position.
2，Located at the bottom of the Battery Housing there is a OFF/AUTO/ON switch:
"AUTO" position, the light will turn on automatically when motion is detected. then both light head
turns on after the motion detect, Red warning will be flashing all the time at night.
"OFF" position, the light will remain off and will not detect any movement
"ON" Position, all the three light head on and maximum brightness.
3，Light Color switch
Located at the back of the light housing, push the button to
switch light color, 3000K Warm white or 6000K White.
4，How to Use Control Dials
The Solar Motion Light has 3 dials which control the light's duration,
sensitivity to light, and sensitivity to motion.
LUX (Light Level)
The LUX dial adjusts the sensitivity to darkness. If set to the maximum
level, the light will go on in daylight. If set to the minimum
the sensor will only trigger the light to turn on at dusk or when it is dark
out. This is the ideal position for general use. Please note that ambient
light will affect the sensor.
Time
The time dial sets the duration the light will stay on when triggered.
The duration is adjustable from 8 seconds to 2 minutes. Rotating the
dial clockwise will increase the duration the light will stay on.
SENS (Sensitivity)
The SENS dial adjusts the sensitivity of motion detection:
1. Minimum position – Low Range: large movement
is required to trigger the light to turn on.
2. Mid Position - Medium setting.
3. Maximum position - Maximum range: the smaller movements will trigger the light to turn on.
Operating Instructions
Page 5 of 8
level,