Setting Level; Recalling Presets; Preset Bank 1 - Compatibility Mode - Seeburg A6 dp User Manual

A6 dp

5.3 Setting level

5.4 Recalling presets

Pressing the Mode button twice selects the Preset Mode. Four presets are available in each bank
for selection via the Set button. The four vertically aligned LEDs indicate the current selection.
5.4.1 Preset Bank 1 – Compatibility Mode
This bank contains a Compatibility Mode. The presets are acoustically compatible with A6 dp sys-
tems that are not fitted with the DPLM-DSP controller.
Pressing the Mode button once selects the Level Mode, in which you
can adjust the output volume in 3 dB steps. There are four settings
available: +3 dB, 0 dB (standard), -3 dB and -6 dB. The setting is
done by pressing the Set button. The Level LED lights to indicate
which mode is activated. The four vertically aligned LEDs (lit green in
this mode) indicate which setting is selected.
Flat:
Preset for single application or in combination with a subwoofer (e.g.
G Sub 1501 dp).
HP 120:
Flat preset with a higher cut-off frequency for the high-pass filter for
combination with a subwoofer. The higher cut-off frequency allows a
higher maximum sound pressure level to be achieved.
Voice:
Flat preset with an additional high-shelf filter that provides a high fre-
quency boost. This setting is intended for applications in which
speech intelligibility is particularly important.
Low-Boost:
Based on the preset Flat with a low-frequency boost. This setting is
useful in full-range applications in which strong bass reproduction is
required, but a subwoofer cannot be used. The achievable low-
frequency level is, however, limited.
10
5 Operation