en Cleaning and servicing
Cleaning the water inlet filter
Clean the filter in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
In order to clean the filter, first empty
the water inlet hose.
Turn off the tap.
1.
Set the algodón/algodão pro-
2.
gramme.
Start the programme and leave it
3.
to run for approx. 70 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Cleaning the filter on the tap
Note: Please read the information in
the Safety → Page 4 and Preventing
material damage → Page 11 sections
to ensure that you use the appliance
safely.
Requirement: The water inlet hose is
empty.
Remove the water inlet hose from
1.
the tap.
52
Clean the filter with a small brush.
2.
Connect the water inlet hose and
3.
check for leaks.