Positioning The Seat; Adjusting The Motion-Control Levers - Toro Titan ZX4800 Operator's Manual

4. Sit on the seat, engage the parking brake,
move the blade-control switch (PTO) to the O
position, and move the motion-control levers
to N -
EUTRAL LOCK
While the engine is running, center either
motion-control lever and move it forward or
reverse; the engine should shut off. Repeat for
other motion-control lever.
5. Sit on the seat, disengage the parking brake,
move the blade-control switch (PTO) to the O
position, and move the motion-control levers to
N - position. Try starting the engine;
EUTRAL LOCK
the engine should not crank.

Positioning the Seat

The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable
position. Start the engine.
(Figure 9).
Figure 9
Adjusting the
FF
Motion-Control Levers
Adjusting the Height
You can adjust the motion-control levers higher or
lower for maximum comfort
FF
Adjusting the Tilt
You can adjust the motion-control levers forward or
rearward for your comfort.
1. Loosen the upper bolt holding the control lever
to the control-arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever forward or rearward
3. Tighten both bolts to secure the control lever in
g027632
the new position.
4. Repeat the adjustment for the other control lever.
15
(Figure 10).
Figure 10
(Figure
g027252
10).