Troubleshooting - Philips S529 Manual

1 Disconnect the appliance from
the wall socket and let the
appliance run until the motor
stops.
2 Insert a screwdriver under the
edge of the upper front panel and
remove it (Fig. 22).
3 Undo the screws in the top part of
the shaver (Fig. 23).
4 Remove the cover in the top of
the handle (Fig. 24).
5 Insert a screwdriver under the
edge of the front panel to remove
the panel and on/off button (Fig.
25).
6 Remove the small inner part
below the on/off button (Fig. 26).
7 Push the inner frame out of the
housing with the screwdriver (Fig.
27).
8 Cut the wires with pliers and
remove the battery (Fig. 28).

Troubleshooting

This chapter summarizes the most
common problems you could
encounter with the appliance. If you
are unable to solve the problem with
the information below, visit
www.philips.com/support for a list
of frequently asked questions or
contact the Consumer Care Center in
your country.
Prob­
lem
The
shaver
does not
work as
well as it
used to.
The
shaver
does not
work
when I
switch it
on.
The
shaving
heads
do not
stay in
place in
the
shaving
unit.
Possible
cause
The
shaving
heads
are
damaged
or worn.
The
shaving
heads
are dirty.
Long
hairs
obstruct
the
shaving
heads.
The
recharge­
able
battery is
low.
The
recharge­
able
battery is
empty.
You did
not fix
the
retaining
frames
properly.
The
shaving
heads
with
projec­
tions are
not
placed
properly.
Solution
Replace the
shaving
heads (see
'Replacement
').
Clean the
shaving
heads (see
'Cleaning and
maintenance
').
Clean the
shaving
heads (see
'Cleaning and
maintenance
').
Switch off the
shaver and
recharge the
battery (see
'Charging').
Switch off the
shaver and
recharge the
battery (see
'Charging').
The retaining
frames are
fixed properly
if you hear a
click when
you push it
back onto the
shaving
heads.
Make sure
that the
shaving
heads with
the
projections fit
exactly onto
the hooks of
the shaving
head holder
when placing
them (Fig.
20).