Table of Contents
Advertisement
Replacement
Usage indicator
For optimal cutting and gliding performance, we
advise you to replace the blade every 6 months,
when it no longer provides the shaving or trimming
results you expect.
The blade is equipped with an usage indicator. A
green bar will gradually appear on the blade as you
use it (Fig. 17). When it is highly visible, it is
recommended to replace your blade for the best
OneBlade experience. Always replace the blade
with original Philips blade.
Depending on your usage behavior, the exact
lifetime of the blade could be longer or shorter.
Similar to a manual blade, the blade becomes
blunt over time, which results in increased hair
pulling and reduced cutting performance.
Replacing the blade
1
Switch off the appliance.
2 Push the blade release slide upwards carefully,
and hold the blade on its sides to remove the
blade and prevent it from flying away (Fig. 18).
3 Hold the new blade on its sides and press it
onto the handle ('click') (Fig. 19).
Note: Be careful, the edges of the blade are sharp.
When you hear a click the new blade is placed
correctly and ready for use.
Ordering accessories
To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your
Philips dealer. You can also contact the Philips
Consumer Care Center in your country (see the
international warranty leaflet for contact details).
The following parts are available:
- QP210 Blade 1-pack
- QP220 Blade 2-pack
- QP610 Replacement blade 1-pack
- QP620 Replacement blade 2-pack
Recycling
- Do not throw away the product with the normal
household waste at the end of its life, but hand
it in at an official collection point for recycling.
By doing this, you help to preserve the
environment.
- This product contains a built-in rechargeable
battery which shall not be disposed of with
normal household waste. Please take your
product to an official collection point or a
Philips service center to have a professional
remove the rechargeable battery.
- Follow your country's rules for the separate
collection of electrical and electronic products
and rechargeable batteries. Correct disposal
helps prevent negative consequences for the
environment and human health.
Removing the rechargeable battery
Removing the rechargeable battery
Only remove the rechargeable battery when
you discard the product. Before you remove
the battery, make sure that the product is
disconnected from the wall socket and that
the battery is completely empty.
Take any necessary safety precautions when
you handle tools to open the product and
when you dispose of the rechargeable battery.
1
Check if there are screws in the back or front of
the appliance. If so, remove them.
2 Remove the back and/or front panel of the
appliance with a screwdriver. If necessary, also
remove additional screws and/or parts until you
see the printed circuit board with the
rechargeable battery.
3 Remove the rechargeable battery.
Troubleshooting
This chapter summarizes the most common
problems you could encounter with the appliance.
If you are unable to solve the problem with the
information below, visit www.philips.com/support
for a list of frequently asked questions or contact
the Consumer Care Center in your country.
Problem
The
appliance
does not
charge
when it is
connected
to the
mains.
I cannot
switch on
the
appliance
when it is
connected
to the
mains.
Possible
cause
The
appliance
has to be
switched
off when
you charge
it.
You cannot
use the
appliance
when it is
charging.
You can
only use
the
appliance
without
cord.
Solution
Switch off the
appliance.
Disconnect the
appliance from the
mains before use.
Advertisement
Table of Contents
