Datamax Mark II M-4206 Operation Instructions Manual page 3

Introduction
The M-Class M1 and M2 series of printers are available with several Communication Card options. These cards can be
equipped in the following configurations:
Wired and Wireless Ethernet and USB Host*
Wired and Wireless Ethernet
Wired Ethernet and USB Host*
* Not avialable on the M1 model.
External Hardware Descriptions
The functions of the Interface Card's external hardware are defined below. Depending on the configuration
of your card some items may not be present.
Connectors
ANTENNA is used to connect an antenna or coaxial cable for RF reception and transmission via this Multimedia
Communication Exchange (MMCX) Reverse Pin type connector.
10/100 BaseT is used to connect a 10/100 BaseT Ethernet cable via this RJ45 network connector. This port can not be used
for the setup of the wireless portion of the card.
Indicator Lights
ACTIVITY is a green indicator that flashes when the Card is not connected and scanning. The indicator will turn on when a
connection is made.
LINK is a yellow indicator that comes on when the Card is associated with an Access Point or Ad-hoc peer.
DATA is a green indicator that flashes when there is data transmitted between the printer and Host access point.
USB Host Ports
The USB Host Ports accept external memory storage devices for fonts, graphics, label formats, and firmware upgrades. Additionally,
the USB Host Ports can accept a USB keyboard for direct data stand-alone input applications (e.g., Line Mode).
Reset Button
When pressed and held for five seconds, this causes the Card to reset to the factory default parameters.
Note: After using this Reset Button the printer must be reset using the front panel before the printer will be able to
communicate with the card. Resetting the printer from the front panel will reset both the printer and the wireless card.
Label
This Label contains the MAC address of the Wireless Card. The MAC address of the printer's wired port is listed on the printer's
configuration test label.
Installing the Antenna (wireless cards only)
1. Extend the Antenna then align the Base to the
Connector.
2. Turn the Base clockwise until fully seated and tight on
the Connector.
3. Raise and position the Antenna.
To avoid permenate damage, do not pull on the antenna when
handling the Wireless Card
O v e r v i e w
Wired Ethernet
USB Host*
Antenna
ANT
ACTIVITY
LINK
DATA
RESET
Connector
Base
1