Datamax Mark II M-4206 Operation Instructions Manual page 12

Wifi Configuration Page (continued...)
Advanced Settings
Maximum Transmission
Rate
Use Fixed Rate for
Transmission
Network IP Settings
Enable DHCP
DHCP Client Name
DHCP Fixed Interval
Retransmission
DHCP Retransmit
Interval
DHCP Acquire Time
Limit
DHCP Fallback IP
Address
DHCP Fallback Subnet
DHCP Fallback Gateway
Static IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
B r o w s i n g t o t h e P r i n t e r ' s I n t e r n a l W e b P a g e s
Specifies the Module's maximum wireless transmission rate. Default is 2 Mbps.
Sets the 802.11 behavior for Ad Hoc mode. Default is 0.
When checked, enables the Dynamic Host Configuration Protocol (DHCP). For this
parameter to work, the AP or network must support DHCP.
Specifies the Module's DHCP client name.
Sets the DHCP retransmission mode to either Exponential (not checked) or Fixed interval
(checked). Default is not checked.
Sets the DHCP retransmission interval to use when "Enable DHCP Fixed Interval
Retransmission" is set to fixed. This is an integer with a range of 1-64. Default is 15.
Sets the number of seconds the DHCP should attempt to acquire an IP address before
using the fallback IP address, if wl-dhcp-fb is on. An integer with a range of 1-255. Default is
150.
Displays the fallback IP address. Default is 192.168.10.1
Displays the fallback subnet mask. Default is 255.255.255.0
Sets the fallback gateway address. Default is 0.0.0.0.
Specifies the Module's static IP address; up to four octets separated by a period. If Enable
DHCP is checked, this parameter is ignored. Default is 0.0.0.0.
Specifies the Module's subnet mask; up to four octets separated by a period.
Default is 255.255.255.0
Displays the Module's LAN IP address; up to four octets separated by a period.
Default is 192.168.0.1.
Displays the primary DNS server address for DNS lookups. If DHCP is enabled, the IP
address provided by the DHCP server is used.
Default is 0.0.0.0.
Displays the secondary DNS server address for DNS lookups when the primary DNS server
is unavailable.
Default is 0.0.0.0.
10