Troubleshooting - Jocel JCHTV–208 Instruction Manual

TROUBLE SHOOTING
Breakdown
The indicator is not on.
The compressor doses not start.
The indicator is on ,but the com-
pressor doesn't work and buzzes
only
The compressor stops a minute
after start, and restart after a few
minutes, and so repeatedly.
The compressor works normally,
but the temperature in the cabinet
lowers too slowly.
The noise is too loud
THE FOLLOWING ARE NOT FAULTS:
 When the freezer is working or after is stops for a while, the refrigerant in the pipes is cycling
and gives out＂running water＂sounds.
 The surface temperature of the compressor may be up 70ºC~80ºC when it is working.
 The back side of step freezer gives out heat.
 In rainy season, the outer surface of the cabinet may have dew, which makes no defects on
normal use. Just dry it with a piece of cloth.
Case
The plug isn't connected to
the
socket really.
no power
The power voltage is＜187V.
The power voltage is＞242V.
The doors are opened too
frequently.
The food in the cabinet is too
much, and placed improperly.
The frost film is too thick.
The surface of the condenser
is too dirty.
The door seals badly.
The freezer is placed
unstably.
The fixing of the freezer is
loose.
there's contact between
pipes.
- 16 -
Removal method
Replug it.
Connect the socket with power.
Put a power-regulater more than
1000W power together.
Reduce open times.
Place foods properly keep place
between them for ventilation of cold
air.
Take out foods and defrost.
Stop and clean the condenser.
Adjust the door seal.
Place it stably.
Tighten the fixing.
Separate them.