Table of Contents
Advertisement
A Note About Nozzles
The nozzle is the brass conical piece with a six sided base. It attaches to
the other parts of the hot end and dispenses material through a precisely
sized hole.
If you wish to remove or change the nozzle, you must first remove the
entire hot end. Attempting to unscrew the nozzle directly from the M3-ID
will damage the hot end.
Some of our users choose to print with nozzles that are either larger or
smaller than the 0.35 mm nozzle included on the M3-ID in order to
accommodate specific printing needs. If you plan to print with different-
sized nozzles, we recommend keeping each nozzle installed in a separate
hot end, as this allows you to switch between nozzles more easily.
Visit the MakerGear YouTube channel for step-by-step instructions on
how to remove the V4 hot end and remove/mount a nozzle.
7
Advertisement
Table of Contents
