Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for INNOSILICON T2Ti-25T BTC
Summary of Contents for INNOSILICON T2Ti-25T BTC
- Page 1 T2Ti-25T BTC USER MANUAL...
-
Page 2: Table Of Contents
Catalogue 1.Overview ......................0 2. Assemble the miner ..................1 2.1 Open the package to check the miner .................. 1 3.Operate the miner....................4 3.1 Enter the miner console ......................4 3.2 Configure the pool ........................ 4 3.3 View the hash rate of the miner ................... 5 3.4 Network configuration ...................... -
Page 3: Overview
1.Overview Specifications T2Ti-25T Part Number Sha256 Algorithm 391mm（L）*141mm(W)*220mm（H） Size (L×W×H) 9.0KG Net Weight 0--45 ℃(device junction temperature) Operating Temperature Ethernet Network Connection Typical Hash rate and Power Dissipation parameters under the four Modes:（Pls refer to 3.5.1 in the manual for mode modification） Mode Performance Factory... -
Page 4: Assemble The Miner
2. Assemble the miner 2.1 Open the package to check the miner ⚫ Check whether the warranty sticker is damaged, especially the one on hash boards PSU port side. If the warranty sticker is damaged when you receive the miner, please contact our after-sales personnel in time. ⚫... - Page 5 2.2 Assemble & Operate Notes：The sequence of the PSU cable must be the same with that in the picture below. Damage caused by any private change is not covered by the warranty. Connect the miner and the router by the Ethernet cable and then the miner can start to run after being powered on.
- Page 6 IP SET button: Press it for 1 to 4 seconds and the following functions can be realized: (1) Sending the IP miner to the “Set IP” tool; (2) Changing the miner to a Static IP within the specific range with the IPset tool Press it for 4 to 15 seconds, the miner IP will be switched to DHCP and the pool settings will be restored to default settings.
-
Page 7: Operate The Miner
3.Operate the miner 3.1 Enter the miner console DHCP is the default IP mode of the miner (The normal indicator now is flickering in green when the DHCP service of the router is enabled.). Find the IP via the router or the IP scanner. Enter the IP of the miner in the browser and press the Enter button. -
Page 8: View The Hash Rate Of The Miner
3.3 View the hash rate of the miner After configuring the pool, the miner will mine for you. You can view the hash rate in the Miner Status screen. 3.4 Network configuration... -
Page 9: Change The Operate Mode
3.5 Other pages 3.5.1 Change the operate mode There are 4 modes available and please click the “Save” icon after your modification. 3.5.2 Overview... -
Page 10: Firmware Upgrade
3.5.3 Firmware upgrade 3.5.4 Modify the login password... -
Page 11: Reboot
3.5.5 Reboot 3.5.6 Factory reset...
Need help?
Do you have a question about the T2Ti-25T BTC and is the answer not in the manual?
Questions and answers