Vaxcel T0062 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0062
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Parts:
Parts Number (4752MM)
Green Grounding
Mounting Plate (A)
Headless Screw (D)
Mounting Screw (B)
Mounting Plate (A)
Lock Nut (F)
House Grounding Wire
Outlet Box
Green Grounding Screw (C)
Fig. 1
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
1. Thread two headless screws through the mounting plate, then secure them with four lock nuts (two
on each side of the mounting plate). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will be
level.
2. Attach the mounting plate to the outlet box by using two mounting screws.
INSTRUCTIONS
Screw (C) Wire Nut (E)
Lock Nut (F)
Fixture Grounding Wire
Clip
Parts Number (7047PC)
Ball Nut (G)
Photocell (I) (X1)
Rubber Pad (H)
Headless Screw (D)
Photocell (I)
Back Plate
Wire Nut (E)
Fixture Wire
Bulb Type A Max.100W
(not included)
Parts Number (9454CS)
Glass Panel (J) (X3)
Loop
Nipple
Rubber Pad (H)
Ball Nut (G)
Metal Frame
Glass Panel (J)
130606