Table of Contents
Advertisement
• The following are the specs of the compression ring terminal connected to your Wired Remote Controller PCB.
mm²
AWG
(inch²)
0.25~1.65
22~16
(0.0003 ~ 0.0025)
• Screws on the PCB terminal must be tightened with less than 6N-cm tightening torque. If the tightening torque is
greater, it may damage the screw thread.
Tracking Your Indoor Unit from the Wired Remote Controller
Displays the total number of
units searched
1
Tracking of your Wired Remote Controller will automatically start when you turn on the power after installation.
2
If you want to perform tracking again after installation, then press the Delete and ESC buttons at the same time for
more than five seconds.
• The system will reset, and tracking will start again.
3
During tracking, the total number of currently searched indoor units and ventilator(ERV) will be displayed.
4
It may take about 5 minutes at initial installation or when you re-set the Master setting.
NOTE
• If you want to perform tracking again after installation, then press the Delete and ESC buttons at the same time
for more than five seconds.
• Only the master Wired Remote Controller can display the total number of indoor units and ventilator(ERV).
– Slave Wired Remote Controllers do not display the total number of units.
W
Stud
F
L
t
Rated Size
Stud Size
mm²
mm
(inch²)
(inch)
1.5 (0.0023)
3 (0.1181)
E
ØD
G
Basic Size [mm (inch)]
t
ØD
G
0.7
3.8
10.0
4.5
(0.0275)
(0.1496)
(0.3937)
(0.1771)
E
F
W
L
6.5
6.0
21.2
(0.2559)
(0.2362)
(0.8346)
Indicates tracking
in progress
English 7
7
Hide quick links:
Advertisement
Table of Contents
