Table of Contents
Advertisement
Wired Remote Controller Installation
Wired Remote Controller Installation
The following are the specs of the compression ring terminal connected to your Wired Remote Controller PCB.
mm²
AWG
(inch²)
0.25~1.65
22~16
(0.0003 ~ 0.0025)
Screws on the PCB terminal must be tightened with less than 6N-cm tightening torque. If the tightening torque is
greater, it may damage the screw thread.
Tracking Your Indoor Unit from the Wired Remote Controller [See the image
1
Tracking of your Wired Remote Controller will automatically start when you turn on the power after installation.
2
If you want to perform tracking again after installation, then press the
more than 5 seconds.
The system will reset, and tracking will start again.
3
During tracking, the total number of currently searched indoor units will be displayed.
4
NOTE
The operation displays on the remote controller may differ depending on the selected language.
If you want to perform tracking again after installation, then press the
more than 5 seconds.
8 English
W
Rated Size Stud Size
mm²
mm
t
(inch²)
(inch)
1.5
3
0.7
(0.0023)
(0.1181)
(0.0275)
E
Stud
F
G
L
t
Basic Size [mm (inch)]
ØD
G
E
3.8
10.0
4.5
(0.1496)
(0.3937)
(0.1771)
and
buttons at the same time for
and
buttons at the same time for
ØD
F
W
L
6.5
6.0
21.2
(0.2559)
(0.2362)
(0.8346)
]
A
Advertisement
Table of Contents
