BenQ BH2801 Installation Manual page 22

Address
(2) Byte2~9 are reserved,
should be 0x00.
Return value: Byte1 - Byte2 -
Byte3...Byte9
The Byte1 at the return value
should be the same as the
value of Byte1 at Input value.
Byte2~Byte15 should be hex
value format
(1) If Byte1=0x00(IP Setup
Mode) at Input value, the
return value should be
Byte1=0x00
Byte2=0x00: Manual
DHCP
Byte3~9 are reserved,
should be 0x00.
(2) If Byte1=0x01(IP Address)
at Input value, the return value
should be
Ex: IP
address=169.254.81.38
Byte1=0x01 (same as
Byte1 at Input value)
Byte2=0xA9 (=169),
Byte3=0xFE (=254),
Byte4=0x51(=81),
Byte5=0x26 (=38)
Byte6~9 are reserved,
should be 0x00.
(3) If Byte1=0x02~0x05 at
Input value, refer to (2)
(4) If Byte1=0x06(MAC
Address) at Input value, the
return value should be
Ex: MAC
address=00:22:64:7E:2C:82
22
Return value: Byte1 - Byte2 -
Byte3...Byte9
The Byte1 at the return value should
be the same as the value of Byte1 at
Input value. Byte2~Byte15 should be
hex value format
(1) If Byte1=0x00(IP Setup Mode) at
Input value, the return value should
be
Byte1=0x00
Byte2=0x00: Manual
Byte3~9 are reserved, should
be 0x00.
(2) If Byte1=0x01(IP Address) at
0x01: Input value, the return value should
be
Ex: IP
address=169.254.81.38
Byte1=0x01 (same as Byte1
at Input value)
Byte2=0xA9 (=169),
Byte3=0xFE (=254),
Byte4=0x51(=81), Byte5=0x26 (=38)
Byte6~9 are reserved, should
be 0x00.
(3) If Byte1=0x02~0x05 at Input
value, refer to (2)
(4) If Byte1=0x06(MAC Address) at
Input value, the return value should
be
Ex: MAC
address=00:22:64:7E:2C:82
Byte1=0x06 (same as Byte1
at Input value)
Byte2=0x00, Byte3=0x22,
Byte4=0x64, Byte5=0x7E,
Byte6=0x2C, Byte7=0x82
Byte8~9 are reserved, should
0x01: DHCP